Leak Sentinel V5 XB Vacuum Leak Detection System with Ikelite 1/2" Adapter

Click image to enlarge

Leak Sentinel v5 XB Ike 1/2"
$260.00
1 item(s)
+

Leak Sentinel V5 XB Vacuum Leak Detection System with Ikelite 1/2" Bulkhead (1/2" - 20) Adapter

NEW IMPROVED XB VERSION! Vivid Housings Leak Sentinel comprehensive vacuum system that allows the underwater photographer to confirm watertight integrity before entering the water. Hand or electric pump not included, order seperately.

Leak Sentinel V5 XB Vacuum Leak Detection System with Ikelite 1/2" Bulkhead (1/2" - 20) Adapter

NEW IMPROVED XB VERSION! For only a fraction of the price of other similar systems, you too can now have Leak Sentinel, pre dive vacuum leak detector that will eliminate guesswork about the housing tightness and let you concentrate on the photography, instead of worrying if today is maybe your turn to experience the underwater photographer's worst nightmare.

This new, improved XB version of Leak Sentinel features new, calibrated pressure sensor and processor. It has a lower profile length and slightly domed bezel. The complete electronic circuit and larger, easy-to-find CR2032 battery are now installed inside the camera housing. You no longer have to disassemble the unit to change the battery. Temperature compensation prevents false alarms, and overnight function makes it possible to set the housing vacuum beforehand, then switch the circuit off and keep on monitoring later without repeating the process, thus saving the battery and time before the dive.

The green/red LEDs are visible through the transparent acrylic window, so no complicated installation around the viewfinder in non-transparent housings is required. LEDs are always visible, not only when you look through the viewfinder.

The installation is simple and straightforward, and is in most cases done by either replacing the bulkhead, or just screwing the adapter into the accessory port, then mounting the battery in a convenient location. You can check the tightness immediately after installation, making the process risk-free.

The circuit is self calibrating, and as such suitable for altitude diving. Manual, spare orings and wire clips are included. Adapters are available if you change housing bulkhead mounts, you can simply buy the adapter.

Note: A hand or electric pump is NOT included, please make your choice from the available accessories.

  • Uses CR2032 watch type battery
  • Temperature Compensation
  • Low Battery Indication
  • Overnight Function
  • Reset Function

No posts found

Write a review

Subscribe Now!

Enter your email address to receive special offers and promotions.