Ikelite High Sensitivity Optical Slave Converter

$150.00
Special order item - Ships Directly from Ikelite!
+

Ikelite Optical Slave Converter for Fiber Optic / Remote Slave Triggering

Trigger your Ikelite DS-series underwater strobe off any camera or strobe flash. The Optical Slave Converter simply attaches to the strobe's electrical bulkhead in place of a sync cord connector. The enlarged slave window provides approximately 90 degrees field of view for remote triggering. Or thread on the included fiber optic port for the attachment of and triggering via a fiber optic cord.

Ikelite High Sensitivity Optical Slave Converter for Remote Triggering of DS Strobes

The High Sensitivity Optical Slave Converter is perfect for use in environments with high ambient light or large distances between your remote strobe and the primary flash.

This is a non-learning, sensor which requires the camera to be in manual flash mode. This Converter will not work with a preflash. The Optical Slave Converter supports manual exposure modes as set on the attached DS strobe. TTL exposure mode is not supported.

If your primary purpose is to trigger a strobe fiber optically by a compact digital camera's flash, we recommend the Fiber Optic Converter # 4401.1 or RC1 Olympus & Panasonic TTL Receiver # 4412 instead.

High Speed Shooting

If you're shooting a DSLR or mirrorless camera with Nauticam fiber optic converter and want to shoot at high frame rates (4 FPS or faster), then this Converter is the right option for you. The included fiber optic port allows the attachment of Ikelite, SEA&SEA, Olympus, and certain Nauticam fiber optic cables.

Attachment and Use

The Converter simply attaches to the strobe's electrical bulkhead in place of a sync cord connector. The enlarged slave window provides approximately 90 degrees field of view for remote triggering.

An optional 3-foot Extension Cord # 4102.03 may be added for more flexible positioning of the sensor window. This set-up is perfect for creative back lighting in wrecks, caves, and pool use. It can also be used above water for studio photography work.

An individual Converter is needed for each strobe. Use of multiple strobes requires one Converter per strobe. The Converter supports DS50, DS51, DS125, DS160 and DS161 strobes.

This product replaces the Optical Slave Converter # 4403.

Specifications

  • 1.1" diameter x 2.7" (28 x 69 mm)
  • Weighs 1.6 oz (45 g)
  • Depth rating 300 ft (90 m)

No posts found

Write a review
  • Similar products