Ikelite Optical Slave Converter for Fiber Optic / Remote Slave Triggering
Trigger your Ikelite DS-series underwater strobe off any camera or strobe flash. The Optical Slave Converter simply attaches to the strobe's electrical bulkhead in place of a sync cord connector. The enlarged slave window provides approximately 90 degrees field of view for remote triggering. Or thread on the included fiber optic port for the attachment of and triggering via a fiber optic cord.
The Optical Slave Converter automatically configures itself for compatibility with both pre-flash and non pre-flash camera modes. No setting of small switches or confusion over number of pre-flashes. Simply turn on your strobe and take one picture to configure.
The Optical Slave Converter can be extended using the optional 3-foot Extension Cord for creative backlighting in wrecks, caves, and pool studio set-ups. It can also be used above water for studio photography work.
The Optical Slave Converter supports manual exposure modes as set on the attached DS strobe. TTL exposure mode is not supported.
An individual Optical Slave Converter is needed for each strobe. Use of multiple strobes requires one Optical Slave Converter per strobe. DS50 and DS125 strobes may also be used with the Optical Slave Converter.
Fiber Optic Cord Compatibility
- Ikelite 4501 Fiber Optic Coiled Cord
- INON Optical D Cable "Non-wireless type" L-Connector
- Sea&Sea Fiber Optic Cable (L-type) Product No. 50107
- Olympus UW Fiber Optic Cable PTCB-E02
- Nauticam Optical Fiber Cable No. 26211 Nauticam to INON
- Nauticam Optical Fiber Cable No. 26212 Nauticam to Sea&Sea
- 1.1 diameter x 2.7 in (28 x 69 mm)
- Weighs 1.6 oz (45 g)
No posts found